How to Overhaul micro powder grinding mill?

The micro powder grinding mill is mainly used for the milling of calcite, limestone, marble, potassium feldspar and other equipment. The main equipment produced by Shanghai Clirik Machinery Co., Ltd. is the micro powder grinding mill-HGM three-ring medium-speed superfine mill. The mill can process a variety of stone materials, the fineness can be freely adjusted to 325 mesh and 3000 mesh, so there is a multi-purpose function.

First, during the use of the micro powder grinding mill, there should be a fixed person responsible for the care. The operator must have a certain level of technology. Before the micro powder grinding mill is installed, the personnel must be trained in the operation to understand the principle performance of the micro powder grinding mill. procedure. In order to make the micro powder grinding mill work normally, the equipment "maintenance and safe operation system" should be established to ensure the long-term safe operation of the micro powder grinding mill, and necessary maintenance tools and grease accessories.

Secondly, after the grinding machine has been used for a period of time, it should be repaired and repaired. At the same time, the wearing parts such as the grinding roller and the blade should be repaired and replaced. The grinding roller device should be carefully checked before and after the use, and the nut plug should be carefully checked for looseness. Whether the lubricating grease is sufficient. When the grinding roller device is used for more than 500 hours to replace the grinding roller, the rolling bearings in the roller sleeve must be cleaned, and the damaged parts should be replaced. The fueling tool can be manually manually refueled or greased. Regular inspections:

1. Whether the screws on the frame, motor base and main bearing are loose.

2. Whether the tank body leaks.

3. Be the scraper and scraper shaft intact?

4.Be there any debris in the tank?

5. Whether the slurry pipe is unobstructed.

6. Be there any oil at each lubrication point?

7, the V-belt should be suitable.

8. Whether the pulley is installed or not.